Forum Replies Created

Viewing 6 reply threads
  • Author
    Posts
    • September 6, 2015 at 1:08 pm #53904
      Larry Prisco
      Participant

      Hi Guys question for yous If I run a 66 an a 13 will I hit the 13k faster that a 79 an a 13?  or what can I do for good speed out of a 125cc Rotax Thanks Larry.

    • April 21, 2015 at 10:18 am #46506
      Larry Prisco
      Participant

      Just to let you know it was something minor the black hose on the carb. the small one that runs side to side was ripped so I replaced it not knowing that is was suppose to be to vet the carb. no problems now Thanks for everybody’s help Larry.

    • April 19, 2015 at 1:07 pm #46355
      Larry Prisco
      Participant

      Inside the carb. on a rotax max on the side where the chock is if you take the screw out an look there is a small hole an the plunger if the plunger is down it covers the hole so does that mean the chock is on? Thanks.

    • April 17, 2015 at 6:11 pm #46284
      Larry Prisco
      Participant

      Do I need to choke it when it hot outside for the first start up? iam going to check all the symptom’s like you said but I think I started it an after I shut it off I chock it . maybe that was the problem to do I need to put this on the stand to start it also sorry about all the questions but it is new to me .Thanks.

    • April 5, 2015 at 7:26 am #45453
      Larry Prisco
      Participant

      It is one off a 2008 crg I know kinda what the new one look like with the fill line but mind doesn’t have one on it . Thanks.

    • March 21, 2015 at 12:11 pm #44542
      Larry Prisco
      Participant

      Could someone tell me please what is the different between the nylon washers an the rubber ones you put on the sides of the seat to mount an how thick they have to be I don’t want to start bending the brackets. Thank Yous.

    • March 5, 2015 at 9:37 am #43468
      Larry Prisco
      Participant

      This is a 125 max an last night I drained the gear oil in it an first the oil looked like rear end fluid it was thick an a greenest blue in color an about about 1/2 oz. came out. is there anything I can do to get it out better can you pour some gas in it to clean it out? an I loosen the bottom bolt to drain the oil an then when I put it back in do I go to the next bolt to the left to make sure the case is full till it comes out the hole hope I didn’t confuse you guy just want to get it right. Thanks Again Larry.

    • April 21, 2015 at 11:21 am #46510
      Larry Prisco
      Participant

      Rob That’s what I did its fine now . I taught it was broke an I fixed it with a new piece of hose an didn’t know it was suppose to have a hole in it. what a dumb – – – .  Larry

    • March 16, 2015 at 2:08 pm #44201
      Larry Prisco
      Participant

      Finch what kind of angle are we looking for on the back of the seat I have a angle finder. Thank you.

  • Author
    Posts
Viewing 6 reply threads