Home Forums Tech Talk Proper placement of H2O sensor on CR125

This topic contains 3 replies, has 3 voices, and was last updated by  Kenneth Culver 4 years, 8 months ago.

  • Author
    Posts
  • #37509

    Kenneth Culver
    Participant

    Where is the proper place to mount the sensor?  Up by the entrance of the radiator or down by the water pump?  I am trying to mount a new mychron 4 and if I mount it by the radiator I guess I will need an additional patch cable?  I cant plug in the EGT and H2O leads unless I mount it by the waterpump.  Any advise would be appreciated!

  • #37530

    I think anywhere on the hose is good but more than likely your gonna need a patch cable but I wouldn’t but it by the water pump. Please anyone correct me if I’m wrong!

  • #37532

    FREDDY SANDOVAL
    Participant

    Cut the hose behind the seat, and install it there, closer towards the engine (right side of the seat)

    Should give you enough clearance to reach the cable to the engine.

    DON’T CUT THE HOSE TILL YOU’RE ABSOLUTELY SURE IT’S GONNA WORK. ;)

  • #37545

    Kenneth Culver
    Participant

    I have always seen them up by the back of the seat.  I figured that if I could put it down by the water pump next to the EGT sensor I could avoid the patch cable.  Doesn’t sound like that is recommended though.

     

    thanks for the help!

You must be logged in to reply to this topic.