Alright…..I hooked up the Odenthal Exactoe 2 and checked the toe. If I am reading it correctly, there was 8mm of toe in on each side. I’m assuming that’s too much as most of what I read before suggested that about 1 mm of toe OUT is a good starting point (at least I think I read that here somewhere). I also used it to check the camber. I don’t know how to read it but the gauge indicates 6mm on each side (tires leaning in at the top). I have no idea what that measurement is supposed to be. This is an older Hasse Blizzard and I have not been able to find ANY setup information on it. Any advice on good starting points on the toe and camber?
Thanks,
TOdd
