Home Forums Shifter Karts How to Check Alignment Reply To: How to Check Alignment

#6855

Chris Reinhardt
Participant

Hey Todd, yes I will be at Summit.  I looked around, I don’t believe I have any info left for the chassis, and honestly, I don’t think the factory had much more than seat location.

Scale the chassis, get your 60%/65% rear weight, 50% side to side, set the rear at 55″, and mess with the front width.  Also, there’s rear ride height on it, I used to run rear in the high position, meaning cassettes as low in the brackets, leave the front bolt loose.

I do have a brandy new steering shaft :) and I have left and right spindles, not sure if they are straight.

CR

Chris Reinhardt

CR2 Motorsports

http://www.cr2motorsports.webs.com/

XV Racing Products

http://www.xvengineering.com/

­­