Alan, thanks for the pics. It looks like your conversion was done by someone different than mine or perhaps because it’s a different carb (I misspoke earlier; my carb is a PWM not ‘K’, so that might explain the differences)
Your evac is closer to front of carb and as you said it’s might be lower in the bowl. It also appears to be straight (mine curves into the bowl).
Hmmm… I think I’ll have to runs some more testing and see if I can narrow it down jetting wise. It may have been way too fat on the bottom last time out; it felt like I was short-shifting everywhere but shift points were normal rpm wise (and over-rev was fine). I might try Fastech to see if they have access to the conversion specs.