Home Forums General Karting Discussion Ribtech Questions Reply To: Ribtech Questions

#38710

Walt Gifford
Participant

Tried squeezing the seat and there’s no adjustment save 1/8″ with a big pre load on the struts which I don’t like.

I think I’m gonna cut a big Vee notch in the back then force it together which will probably rupture the fibers in the mid section, might have to beat it with a hammer to relieve stress in areas then glass it all back together. I just hope the side angles are ok so the top edge doesn’t dig in. If it does dig in probably just beat it with a hammer to get the top to roll out.

Gif

FAA certified jet engine and aircraft technician,
Nicholson Speedway class champion 2001,
Yamaha KT100 Service Center,
41 years karting experience