| View previous topic :: View next topic |
| Author |
Message |
Randy Mckee
Joined: 23 Jul 2001
Posts: 746
Location: United States, California,
|
 Posted: Tue Feb 05, 2013 7:55 pm Post subject: Crankcase hosed |
 |
|
Looks like I dodged a bullet. This is the left side crankcase half near the main bearing. Other side looks fine. Have you guys seen this before? Ideas as to cause?
_________________
Randy
#123 TonyKart - S4 Stock Honda |
|
| Back to top |
|
 |
Jim McMahon
Joined: 07 Apr 2007
Posts: 2666
Location: United States, St. Paul,
|
|
| Back to top |
|
|
Benn Herr
Joined: 18 Jul 2001
Posts: 1579
|
|
| Back to top |
|
|
Randy Mckee
Joined: 23 Jul 2001
Posts: 746
Location: United States, California,
|
| Posted: Wed Feb 06, 2013 12:38 pm Post subject: |
|
|
It is a curiosity. I think the bearing is the original, because this is the first bottom-end rebuild. I did have a motor mount failure at the front, and ran it an entire heat race with the motor vibrating like crazy. Ran fine and have run it for 2 years since that incident.
The cracks don't go all the way through, however there are similar cracks on the outside (but in a different spot).
Just wondering if anyone has seen this before. Just a bad case of a bad case?
_________________
Randy
#123 TonyKart - S4 Stock Honda |
|
| Back to top |
|
|
Christian Hubbell
Joined: 01 Feb 2006
Posts: 236
Location: United States, Michigan, Waterford
|
| Posted: Wed Feb 06, 2013 6:49 pm Post subject: |
|
|
| I'd say ice but water shouldn't be in there. |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Login to check your private messages
Login
