Home Forums Shifter Karts gear shift lever options

This topic contains 1 reply, has 2 voices, and was last updated by  FREDDY SANDOVAL 7 months, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #62973

    Jack Cook

    I just switched to Tony kart for my shifter. i am finding I do not like to location of the gear shift lever, it is to low for my liking. I was using a CRG and found that lever better to my liking. My question is are there any options for the tony kart shift lever.



    Can you post some pictures of your set up?

    That way we can understand better about your issue.

    Is it the height from steering shaft? ( vertical)

    Or forward to back? (too far from steering wheel)

    If it’s the height of steering wheel, you can just trim the steering shaft at the top, where the hub goes, and just drill a new hole.

    But if the shifter lever is too far back, then install a longer rod.

    You may also need a 10 or 15 degree angle/wedge foe your steering hub.

    Anyhow, hope that helps. FastFreddy.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Karting's News and Information Leader ekartingnews | an HMG publication