This topic contains 0 replies, has 1 voice, and was last updated by Todd Kageals 2 years, 1 month ago.
-
I’m getting out of karting. I have a set of ’99 CR125 cases in which I have installed all new OEM Honda bearings. The crank bearings have been slip fit. I have installed a 6 speed gearbox and a brand new OEM Honda crank. I have assembled it out to the clutch basket but have not tightenened anything down. The gaskets have not been compressed. You can pull it a part to inspect everything or you can just tighten all the case bolts, etc. It’s a complete lower end including the clutch, etc. If I can get the pictures to work, I will post them here. Otherwise, email for pictures. I’ll throw in any spare CR125 gaskets/bearings I have accumulated over the years. $700 OBO
https://1drv.ms/i/s!AhKKK6jP1oxOiU_LFbbRhhtnmaDH
You must be logged in to reply to this topic.
