Home Forums General Karting Discussion Belly Pan Bolts

This topic contains 2 replies, has 3 voices, and was last updated by  Troy Berry 2 years, 2 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #51187

    Walt Gifford
    Participant

    How many meat hooks do you have hanging under your kart if you run someone over? Heads go on the bottom on every kart I prepare.

    Gif

    FAA certified jet engine and aircraft technician,
    Nicholson Speedway class champion 2001,
    Yamaha KT100 Service Center,
    41 years karting experience

    #51192

    FREDDY SANDOVAL
    Participant

    Yup, That’s how I set mine up too, even when you install a new set of chassis protectors, the hardware is designed for heads at bottom, washers and nuts on top.

    Meat hooks, Lol. I like that. You’re funny Walt.

    #51297

    Troy Berry
    Participant

    I take it a step farther and buy elevator bolts, and grind the square part down. I also cup them just slightly before install and they sit very flush on the bottom of the floor pan.

    http://www.amazon.com/Hillman-Group-4750-1-Inch-Elevator/dp/B00II5Z860/ref=sr_1_6?s=industrial&ie=UTF8&qid=1436660486&sr=1-6&keywords=1%2F4+inch+elevator+bolts

    I also use a conical washer on top under the nylock nut. They make a good washer and it gives it a nice finished look. They are pretty sweet!

    "The Art is in the details"
    BirelArt AM29 LO206
    Intrepid Cruiser LO 206

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.

Karting's News and Information Leader ekartingnews | an HMG publication