Since my front rotor carriers are worn out and being replaced (thank you Ian) I figure I’ll do the wheel bearings too. Question is are they pressed in or do you just heat the upright up a bit and slide them out?
Tryng to get there to at least help administer the event. Probably not running as I don’t have the needed parts yet. I’m trying to fabricate some bushings for my wallowed out rotor carriers to see if I can get one more run out of them till parts arrive. The rotors were flopping around so bad at Thunderhill my wrist still hurts from the massive vibration.
And yes I like running with Mr Fanning too. Us old farts need to stick together!