Home Forums Chassis & Handling Toe Sweep Alignment Measurement??? Reply To: Toe Sweep Alignment Measurement???

#52529

FREDDY SANDOVAL
Participant

Jerry

Eric and Barry are both right, By just reading your post and noticed you crashed, or even before I read the part where you said you crashed, and mentioned you had a pull, I knew right away that you had something bent.

Check your spindles, your king pins, check your caster adjustment

A bad toe setting will not cause a pull, only negative caster or set back

loosen up your king pin bolts, spin the bolt from the top  (head), if the spindle changes direction as you turn it, then you have bent king pins, replace them and check again.

It is very important that you buy a set of snipe lazer tool, or borrow one, that way you can be sure where your camber and toe is.

What kind of kart is this?

Karting's News and Information Leader ekartingnews | an HMG publication