Home Forums General Karting Discussion Tony Kart EVX set up details? Reply To: Tony Kart EVX set up details?

#26854

Rod Hawkins
Participant

Thanks, ¬†found some info online, but it wasn’t easy (this is for an EVXX, which is close and different tires)

http://www.stablekarting.com.au/news/detail.asp?iNews=8936&iType=100
Set Up sheet – Kart Model: Tony Racer EVXX

Condition: Normal Grip Circuits
Date: 2010
Tyre : MG Yellow Tyre

Rear Track: Tony Kart wheels, rim to rim, o/side to o/side; 1385mm (1390mm max.)

Usually 1385 and leave

Front Track: Tony Kart wheels,

Top of inside front rim to centre of kingpin —- 125 mm_135 mm (start at 130 mm)

Rear Bar: out

Front bar: in and flat (we also have three types of round torsion bars)

Rear ride height: STD, i.e. chassis middle

Caster: add caster if circuit is twisty/tight (can be driver dependant)

MG tyres normally require additional caster,

Rear wheel hubs: standard i.e. 85mm

Rear axle: Tony type N (H is harder, P or E is softer)

Front crash bar: Usually tight

Front lower crash bar: tight

Front ride height: STD i.e. middle of c section

Seat stays: one per side (for more rear grip add additional stay to brake side)

Side pods: loose

Tyre pressure: 10_10.5 psi

Front Hubs: 80mm long (std on Racer EVXX)

Toe out: 2mm total

Wheel Type: Tony Kart magnesium wheels all round

This set up sheet is for circuit that offer normal grip levels for the duration of the event.

It is not intended for a Green circuit or a circuit that has worn out stones.